Willkommen, Gast
Benutzername: Passwort: Angemeldet bleiben:

THEMA: G25 throttle axis problem -> sensor cleaning

G25 throttle axis problem -> sensor cleaning 26 Dez 2010 17:25 #274181

on a straight i noticed i was fallin back to 60% throttle sometimes. Sucks if u lookin for 0,5 sec's i gues =)

so i open the pedal box (first remove pedal plate's) and find lots of cat hairs and other dust. clean all , grease black plastic gears again, inside case must be 100% clean
let some oil go thru the sensors (cooling oil to drill holes i used)
this takes al dirt along with it
after this i blowed it out with air compressor
immediatly tyred it out,
and the signal was stable again
before it was jumping around the whole time...
also check if all plastik greased-gears connected to the sensor-levers are still in the right position (the same position as the other 2)

Full Throttle greetings
pSyTech
Der Administrator hat öffentliche Schreibrechte deaktiviert.

Aw: G25 throttle axis problem -> sensor cleaning 26 Dez 2010 18:50 #274183

Thanks psytech, you know I have the same problem (we talked about it at Oldring), so I think it is just the potentiometer (dunno if there is an english translation ^^ ) wich needs a bit of Mos2 or sth. similar.
Will give it a try next week. Thanks for your Post.
Cheers
Maxi
Der Administrator hat öffentliche Schreibrechte deaktiviert.

Aw: G25 throttle axis problem -> sensor cleaning 26 Dez 2010 19:38 #274186

yup flush the potentiometer/sensor with oil will do the trick
Der Administrator hat öffentliche Schreibrechte deaktiviert.
Ladezeit der Seite: 0.028 Sekunden
Powered by Kunena Forum